OTC Tools & Equipment

Ford TBI Noid Lite Noid Lites are the fastest, easiest, most economical way to check electronic fuel injection signals.. Simply disconnect the fuel injectors, plug the Noid Lite into the injector...

Exhaust Hanger Pliers Quickly and easily remove rubber push-through brackets from their hangers. . Two-position slip joint for use on many sizes of hanger blocks. 7677

Ford Power Steering Pump Pulley Installer Installs power steering pump pulleys on: 1992-newer Ford Crown Victoria and Mercury Grand Marquis with 4.6 V8 engine, 1997-newer Ford truck with 4.2 & 4.6...

Flange-Type Puller Set Removes a wide variety of components having tapped holes, including harmonic balancers and timing gears.. Includes a variety of sizes of standard and metric cap screws. ...

Decarbonizing Adapter Access fittings, adapters and accessories for fuel injection service and cleaning. For both domestic and imported vehicles. 7666

4WD Ball Joint Service Set This kit is used with ball joint service kit No. 7249 to remove and install upper and lower ball joints on 1967-current 1/2- and 3/4-ton 4WD vehicles having the Dana44...

Front Hub Installer Used to pull the axle shaft into the front hub.. Fits axle shafts with 22 mm x 1.5 thread on Ford Contour/Mystique, Probe, and Focus. 7924A

GM 4WD Ball Joint Adapter Set Use this set with your No.7249 ball joint service tool set to service GM’s 1996 and newer 4WD 1/2 and 3/4 ton pickups, Suburbans and Yukons/Tahoes. Easily remove or...

Front Hub Puller for 4WD Vehicles Needed to remove the front hub assembly when wheel bearing or brake rotor service is required. Services 3/4- and 1-ton 4WD pickups with 8-bolt hubs: 1994 and newer...

Ford Ball Joint Adapter Set Allows easy removal and installation of the lower ball joint on 1996–2004 Ford Taurus and Mercury Sable vehicles.. Lower ball joint can now be replaced without having to...

Silver ­Slapper 8-Way Slide Hammer Puller Set You can pull flange-type rear axles, remove stubborn oil seals and bearings and other press-fit parts. Puller jaws can be set up for 2/3 jaw internal or...

External-Internal Threaded Adapter External-Internal Threaded Adapter For use on the ends of Push-Puller legs or forcing screws when pulling shafts, bearing caps, pinions, etc. No. 8005 Internal...