OTC Tools & Equipment

Front Hub Installer Used to pull the axle shaft into the front hub.. Fits axle shafts with 22 mm x 1.5 thread on Ford Contour/Mystique, Probe, and Focus. 7924A

GM 4WD Ball Joint Adapter Set Use this set with your No.7249 ball joint service tool set to service GM’s 1996 and newer 4WD 1/2 and 3/4 ton pickups, Suburbans and Yukons/Tahoes. Easily remove or...

Front Hub Puller for 4WD Vehicles Needed to remove the front hub assembly when wheel bearing or brake rotor service is required. Services 3/4- and 1-ton 4WD pickups with 8-bolt hubs: 1994 and newer...

Ford Ball Joint Adapter Set Allows easy removal and installation of the lower ball joint on 1996–2004 Ford Taurus and Mercury Sable vehicles.. Lower ball joint can now be replaced without having to...

Silver ­Slapper 8-Way Slide Hammer Puller Set You can pull flange-type rear axles, remove stubborn oil seals and bearings and other press-fit parts. Puller jaws can be set up for 2/3 jaw internal or...

External-Internal Threaded Adapter External-Internal Threaded Adapter For use on the ends of Push-Puller legs or forcing screws when pulling shafts, bearing caps, pinions, etc. No. 8005 Internal...

Internal Threaded Adapters, 5/8"–18 x 3/4"–16 Female End “A” 5/8–18 Female End “B” ¾” -16 8038

Fluid Evacuation / Brake Bleeding Tool Use to bleed brake systems and remove a variety of fluid from vehicles, such as antifreeze, oil, transmission fluid, gear lube, etc.. Quick connect locking hose...

2 Pc. Handled Pry Bar Set 12 and 18 handled pry bar included. Durable dual durometer handle. Lifetime Warranty 8252

Connected Adapter Ball J oint Extension Connected adapter Ball Joint Extension. Allows CA6636 to be oriented in either direction. Provides extra clearance for ball joint studs on drive screw side...

Ford '93 & Newer System II Air Bag Simulator Special 2 ohm air bag simulator for use on Ford '93 & newer System II air bags 7956

Head assembly only for 1173 Slide Hammer Head assembly only for 1173 Slide Hammer Jaw spread of 1/2 to 1-3/8, adjusted by turning the slide hammer handle. Fits handle end with a 1/2–20 thread. No...