Brake Tire and

Ford Ball Joint Adapter Set Allows easy removal and installation of the lower ball joint on 1996–2004 Ford Taurus and Mercury Sable vehicles.. Lower ball joint can now be replaced without having to replace the entire spindle assembly saving up to an hour...

Ford Ball Joint Adapter Update Kit Three-piece kit contains specialty ball joint adapters for use with the industry standard OTC-7248 C-frame. Designed to work with the following Ford vehicles: . F-150 1997-2003 . F-250 1997-2004 . F-350 1992-2004 ...

Ford Ball Joint Remover When used with OTC-7249 ball joint service tool set, the OTC-7825 lets you quickly remove the lower ball joint on 1992 and newer 3/4- and 1-ton full-size vans (E-250 and E-350) 7825

Ford Caster/Camber Adjusting Wrench Ford Caster/Camber Adjusting Wrench This wrench is specially bent to fit on the caster/camber adjusting cam on 1995 to 2001 Ford Explorer 4WD SUVs, and 1997 2WD and 4WD F-150 pickups. You can use it on the nut to...

Ford Heavy Duty Pitman Arm Puller For 2005 and Later Ford F250 & F350. A heavy-duty puller for the large Pitman arms on Ford 250 and 350 trucks. Jaws are forged and heat-treated for strength. Position puller jaws under the Pitman arm, turn center screw...

Ford Transit Connect Van Ball Joint Adapter Set This 4-adapter set is used in conjunction with the 7248 C-frame to remove and install ball joints on Ford Transit Connect Vans. Set contains adapter part numbers 580517, 580526, 581646, and 581647 for use...

Ford Truck Torsion Bar Tool Ford Truck Torsion Bar Tool This tool firmly holds the torsion bar on Ford light-duty trucks while you adjust or service the front suspension. Without it, a torsion bar could unwind and possibly cause damage. The tool fits...

Front Coil Spring Compressor Front Coil Spring Compressor This compressor fits most late-model rear wheel drive domestic vehicles in which the coil springs are between the upper and lower control arms. The tool features four case-hardened, self-aligning...

Front Hub Installer Used to pull the axle shaft into the front hub.. Fits axle shafts with 22 mm x 1.5 thread on Ford Contour/Mystique, Probe, and Focus. 7924A

Front Hub Puller for 4WD Vehicles For removal of the front hub assembly, necessary for wheel bearing or brake rotor service. Provides the mechanical advantage and straight pull not possible with a slide hammer.. Will not work on trucks with dual rear...

FWD Axle Nut Sockets 36mm Durable, impact-grade material. Deep to fit over variable axle lengths. Works where standard sockets won't. Use 1/2 drive. 39550

GM 4WD Ball Joint Adapter Set Use this set with your No.7249 ball joint service tool set to service GM’s 1996 and newer 4WD 1/2 and 3/4 ton pickups, Suburbans and Yukons/Tahoes. Easily remove or install either aftermarket or original equipment press-fit...