Brake Tire and

Driver Handle For Pneumatic Fan Clutch Wrench Set (43300) 43370

External-Internal Threaded Adapter External-Internal Threaded Adapter For use on the ends of Push-Puller legs or forcing screws when pulling shafts, bearing caps, pinions, etc. No. 8005 Internal End 5/8–18 External End 3/8–16 Length 2-1/4 8005

Forcing Scew Nut Features and Benefits: . Ships from 1 of 10 warehouses around the country: You get your tools FAST with standard shipping!. Poster Tube is made of a very rigid plastic to protect contents from bending or creasing in transit. Tube is also...

Ford Ball Joint Adapter Set Allows easy removal and installation of the lower ball joint on 1996–2004 Ford Taurus and Mercury Sable vehicles.. Lower ball joint can now be replaced without having to replace the entire spindle assembly saving up to an hour...

Ford Ball Joint Adapter Update Kit Three-piece kit contains specialty ball joint adapters for use with the industry standard OTC-7248 C-frame. Designed to work with the following Ford vehicles: . F-150 1997-2003 . F-250 1997-2004 . F-350 1992-2004 ...

Ford Ball Joint Remover When used with OTC-7249 ball joint service tool set, the OTC-7825 lets you quickly remove the lower ball joint on 1992 and newer 3/4- and 1-ton full-size vans (E-250 and E-350) 7825

Ford Heavy Duty Pitman Arm Puller For 2005 and Later Ford F250 & F350. A heavy-duty puller for the large Pitman arms on Ford 250 and 350 trucks. Jaws are forged and heat-treated for strength. Position puller jaws under the Pitman arm, turn center screw...

Ford Transit Connect Van Ball Joint Adapter Set This 4-adapter set is used in conjunction with the 7248 C-frame to remove and install ball joints on Ford Transit Connect Vans. Set contains adapter part numbers 580517, 580526, 581646, and 581647 for use...

Ford Truck Torsion Bar Tool Ford Truck Torsion Bar Tool This tool firmly holds the torsion bar on Ford light-duty trucks while you adjust or service the front suspension. Without it, a torsion bar could unwind and possibly cause damage. The tool fits...

Front Coil Spring Compressor Front Coil Spring Compressor This compressor fits most late-model rear wheel drive domestic vehicles in which the coil springs are between the upper and lower control arms. The tool features four case-hardened, self-aligning...

Front Hub Installer Used to pull the axle shaft into the front hub.. Fits axle shafts with 22 mm x 1.5 thread on Ford Contour/Mystique, Probe, and Focus. 7924A

Front Hub Puller for 4WD Vehicles For removal of the front hub assembly, necessary for wheel bearing or brake rotor service. Provides the mechanical advantage and straight pull not possible with a slide hammer.. Will not work on trucks with dual rear...