Pumps and

Includes ejector, gasket, and bolts. Will lift water from depths of up to 90'. Must be 4" minimum well casing for deep-well application. Dual voltage (115V/230V). Pressure switch factory preset at charted discharge pressure.

Includes ejector, gasket, and bolts. Will lift water from depths of up to 90'. Must be 4" minimum well casing for deep-well application. Dual voltage (115V/230V). Pressure switch factory preset at charted discharge pressure.

The Superior Pump 25 Ft. lay-flat discharge hose kit is designed to work with most sump and utility pumps with a pump discharge size of 1-1/4 In. or 1-1/2 In. The 25 Ft. long x 1-1/2 In. diameter lay-flat hose is made from reinforced PVC and easily rolls...

Superior Pump builds pumps that are truly built to last and are 100% factory tested. Superior Pump uses quality components including solid copper motor windings, heavy-duty stainless steel jacketed shaft seals, double o-ring seals on motor plate, and...

Superior Pump builds pumps that are truly built to last and are 100% factory tested. Superior Pump uses quality components including solid copper motor windings, heavy-duty stainless steel jacketed shaft seals, double o-ring seals on motor plate, and...

Superior Pump builds pumps that are truly built to last and are 100 percent factory tested. Superior Pump uses quality components including solid copper motor windings, heavy-duty stainless steel jacketed shaft seals, double o ring seals on motor plate,...

Factory pre-charge: 38 psi (pounds per square inch). Maximum working pressure 100 psi. Maximum operating temperature 200 F (degree Fahrenheit). Engineered to provide years of trouble-free service using cold rolled steel for a higher strength to weight...

Diaphragm-type pre-pressurized expansion tank specifically designed for potable hot water systems. These tanks control water pressure build-up and eliminate relief valve spillage caused by thermal expansion when water is heated. 3/4" Male pipe thread...

The Wayne PC2 portable electric water transfer water pump is powered by a compact but powerful 115 volt motor. Lifts water over 35 Ft., removes water down to 1/8 In. of surface with suction attachment (included). Rugged, metal pump and motor housing. 3/4...

Zoeller Pro Cast Iron Sump Pump, non-clogging vortex impeller. 1-1/2 In. NPT discharge - passes 3/8 In. solids. All stainless steel hardware. Premium vertical switch easily fits into as small as a 10 In. sump basin. Rugged cast iron motor housing for...

Round hole plated steel for rust resistance. Strainer helps to keep pump damaging solids from entering the pump. For use on suction hoses where foot valve is not required.

Plastic suction hose strainer, will not be affected by chemicals or salt water. For use on suction hoses where foot valve is not required. 2-inch inside diameter.