Stove

(DSA)-without coupler. For use in retrofit installations, this part can be installed from below with a finish support package and secured with screws. Used to connect either model DS smoke pipe or single wall stove pipe to SSII type HT insulated chimney...

For freestanding fireplaces and open cathedral ceiling installations. Fits all roof pitches and requires only simple framing. Mounts easily onto top of roof through opening that allows 2" clearance. Maximum length of chimney which can be suspended below...

Used to start chimneys indoors or outdoors using a wall support assembly or masonry pier. Insulated tee cap included, removable for inspection and cleanout. Maximum height of chimney which can be supported by an insulated tee is 50'.

Includes the basic components for a standard installation (2/12 - 6/12). Contains 1 round top, 1 storm collar, and 1 roof flashing. For use with Model SSII Type HT chimneys.

For a wall supported chimney system with a horizontal connector passing through an exterior wall, connecting to a Tee and running vertically up the exterior wall to termination above the roof line. The Thru-the-Wall Support Kit provides all necessary...

Stainless steel outer casing and inner liner. Double-wall pipe with solid pack insulation. Tested to withstand 2100 F (degree Fahrenheit). UL (Underwriters' Laboratories) listed. This test helps to prevent product damage or structural hazard during brief...

With proper framing, both ceiling supports assure at least 2" minimum clearance to combustibles at the support level and can carry up to 50' of vertical chimney height. Square trim plate. Matte black finish.

For freestanding fireplaces and open cathedral ceiling installations. Fits all roof pitches and requires only simple framing. Mounts easily onto top of roof through opening that allows 2" clearance. Maximum length of chimney which can be suspended below...

3" storm collar. Type L insulated pipe for pellet stove applications. Used to provide a weather proof seal to pipe above roof flashing. Seal inner edge with hi-temp silicone sealant. Size: A 3-5/8".

3" pellet vent through the wall kit includes 1 pipe adaptor, 1 wall thimble, 1 tee with cleanout, 5-1' pipe lengths, 1 wall strap, one 90 deg. elbow, and 1 horizontal cap.

Exit cap for pellet stove pipe, 5-3/4" high for 3" pipe. Galvanized.

(DSAC)-with coupler. For use in new installations, this part can be installed by twist-locking the coupler on the DSAC into the first section of Model SSII type HT chimney pipe. Used to connect either model DS smoke pipe or single wall stove pipe to SSII...