Heating and Cooling

Easy to assemble and can be combined to obtain the required installation height. Couplers overlap 1-1/2" when joined. Assembled length is 1-1/2" less than listed lengths. Size refers to the inside diameter of the pipe or fitting. The outside diameter of...

Used when an offset is required to avoid obstructions such as rafters, joists and other construction obstacles. Used to orient pipe between vertical and horizontal orientation. Four piece adjustable elbow twists for easy offsets. Size refers to the...

Cap to seal off an unused opening in your gas vent pipe. Used at bottom of Tee. Removeable for easy system maintenance. Size refers to the inside diameter of the pipe or fitting. The outside diameter of RV is approximately 1/2" larger. Type B gas vent.

Used to ensure clearance to combustibles is maintained. Also serves as a firestop. Adjusts from 4-1/8" to 7" to fit thickness of wall. Type B gas vent.

Selkirk RV round vent pipe is a Listed Type "B" gas vent pipe. Its adjustable fittings and standard short lengths eliminate all cutting, fitting and special engineering. An improved joint design provides for a rapid and secure connection in seconds. The...

Used in combination with a straight length, this component assures that an exact required vent length can be achieved. Allows for easy disassembly and can absorb the linear expansion of longer pipe lengths. 12" length adjusts from 3-1/2" to 10-1/2", 18"...

Easy to assemble and can be combined to obtain the required installation height. Couplers overlap 1-1/2" when joined. Assembled length is 1-1/2" less than listed lengths. Size refers to the inside diameter of the pipe or fitting. The outside diameter of...

For use when installing a Model SSII chimney in an A-frame, mobile home, or in a ceiling under a narrow section of roof. It provides a finished installation at a ceiling level and will support up to 20' of 6" or 8" diameter chimney. The part also can be...

(DSA)-without coupler. For use in retrofit installations, this part can be installed from below with a finish support package and secured with screws. Used to connect either model DS smoke pipe or single wall stove pipe to SSII type HT insulated chimney...

For freestanding fireplaces and open cathedral ceiling installations. Fits all roof pitches and requires only simple framing. Mounts easily onto top of roof through opening that allows 2" clearance. Maximum length of chimney which can be suspended below...

Used to start chimneys indoors or outdoors using a wall support assembly or masonry pier. Insulated tee cap included, removable for inspection and cleanout. Maximum height of chimney which can be supported by an insulated tee is 50'.

Includes the basic components for a standard installation (2/12 - 6/12). Contains 1 round top, 1 storm collar, and 1 roof flashing. For use with Model SSII Type HT chimneys.