Cogged V-Belt, Power King Cog, AX64, AX, NR, 66 in, 1-2 in Top Width 6L245

The DAYTON - 6L245 is a Cogged, Classical V-Belt designed for general industrial applications. This belt is constructed with materials that may offer some resistance to certain environmental factors like heat and chemicals. The rubber coating on the belt is intended to improve grip, and the raw edge construction is designed for potential efficiency in power transmission. Key Features of the DAYTON - 6L245 V-Belt: Belt Series: It's part of the Power King Cog series, which are used in a variety of industrial settings. For Minimum Pulley Pitch Diameter: With a minimum pulley pitch diameter of 2.2 inches, it has been used in diverse machinery systems. Number of Ribs: The single rib present in this V-belt is designed with an aim to distribute load evenly which could potentially enhance power transmission efficiency. Outside Length & Top Width: Has an outside length measurement of 66 inches and top width measurement of half an inch; these dimensions should be considered when determining compatibility with specific types of machinery or equipment. V-Belt Section: Classified under AX section indicating its specific dimensions and compatibility with certain mechanical applications. Resistance Properties: Designed with materials that may exhibit some resistance against heat, oil and static conduction under certain conditions Tensile Strength & Operating Temperature Range: Has been tested up to a tensile strength limit at approximately 3,400 N/mm and an operating temperature range between -22 Degrees F to 194 Degrees F. These factors may influence its performance under different conditions.