Wedged Cogged V-Belt, Power Ace Cog, 5VX650, 5VX, NR, 65 in, 5-8 in Top Width

The DAYTON - 2L423 is a Cogged, Wedge V-Belt designed for general industrial applications. This belt is constructed with materials that may offer some resistance to certain environmental factors like heat and chemicals. The cogged design is intended for potential improvement in grip, load distribution, and power transmission efficiency. Key Features of the DAYTON - 2L423 V-Belt: Belt Material: Made of gum rubber with a fabric cover and polyester cords which are expected to contribute towards its longevity. Construction: The cogged design is intended to potentially improve grip, load distribution, aiding in the efficiency of power transmission. Minimum Pulley Pitch Diameter: Compatible with pulleys having a pitch diameter not less than 4.4 inches. Number of Ribs: Comes with one rib that is designed to potentially enhance the belt's performance across different industrial applications by reinforcing its structure. Outside Length: Has an outer perimeter measurement of approximately 65 inches; compatibility depends on specific machinery drive system requirements. Tensile Strength: Has been tested up to a tensile strength limit of approximately 5,900 N/mm; actual performance may vary based on usage conditions V-Belt Section & Type: Classified under the '5VX' section indicating specific dimensions compatible with certain types of machinery; it features a 'wedge-cogged' type design intended for use across diverse mechanical applications depending upon compatibility.