Oxygen Sensor

Oxygen Sensor Socket - Thin Wall - 7/8" (22mm) Removes and installs 22mm Oxygen Sensors that cannot be accessed with standard sockets. 1/2 square drive & 1 hex drive. OAL: 31/2” (90mm). Tapered end OD: 29.80mm. Oxygen sensor opening length: 72.7mm 2064

1” Socket, 3/8"Drive, Low Profile Engine Sensor Socket, 22901 Ford Power Stroke 6.0L-V8 td (early model) that use 1” engine sensors.Patented, 1” socket design with 3/8”-drive and a 19mm hex for tight clearance..Compact design measures 2” tall and only 1...

1/2" Drive Oxygen Sensor Socket, Universal Fit Forged from CR-V alloy steel for maximum strength . Works on all domestic and imported vehicles with oxygen . This socket is not intended for use with an impact tool of any kind. . Caution: use of this...

11PC OXYGEN SENSOR SOCKET SET 11PC Oxygen Sensor Socket Set, provides an easy method to remove and install various sensors, sending unit, vacuum switches and Injectors on most domestic and import vehicles. Offset sockets are comprised of SAE and Metric...

15510 24mm NOX and Soot Sensor Socket Our 15510 socket is designed to remove NOX, and particulate matter (SOOT) sensors without damaging the sensor. Because of heat cycles and the corrosive environment of the modern diesel exhaust system, these sensors...

17mm Oxygen Sensor Wrench - Land Rover - 17mm 17mm hex with 3/8” square drive.. Fits all Gems engine Land Rovers, including:. Range Rover Classic ’87 – ’95. Range Rover 4.0/4.6 ’95 – ’98. Discover 1 ’94 – ’99. Defender ’90, ’94 – ’97. Defender 110 ’9...

24mm / 27mm Sensor Sockets Set includes both 24mm and 27mm sockets with 3/8-drive. Forged from alloy steel for strength and durability. Compact design allows them to reach confined areas. Works with sensors on import or domestic and gas or diesel engines...

5 Pc. Exhaust Gas Sensor Socket Set Designed to make removal and installation of O2, NOx and EGT sensors fast and damage-free.Features a side slot that slips over the sensor wiring, so there’s no need to disconnect the harness before removal.Built from...

6 pc. Oxygen Sensor Service Set This Titan 5pc Oxygen Sensor Service Set easily remove, inspect, replace, and install 7/8 (22 mm) oxygen sensors and vacuum switches on most vehicles with this versatile Oxygen Sensor Service Kit. .Each component is...

7 pc. Sensor & Sending Unit Socket Set Set Includes: 1 & 1-1/16 Oil Pressure Sending Unit Socket Includes a 1 and 1-1/16 hex which allows the removal of oil pressure sending units. Special deep design fits switches up to 2-5/8. Designed to be used with a...

8 Pc. Sensor & Sending Socket Set Designed for the removal and installation of oxygen sensors, oil pressure sending units, and vacuum switches. Set includes:. 1/2 Drive 1-13/16 (29mm) Oil Sender Socket. 3/8 Drive 7/8 Slotted Socket for PVS, TVS, and O2...

Dual Drive Oxygen Sensor Wrench Use with a Breaker Bar to Loosen Stubborn Oxygen Sensors. Tool comes with both 1/2” and 3/8” drive. Attach a 1/2” breaker bar on the end of the tool to initially loosen stuck sensors. Use a 3/8” ratchet on the top for...