Clutch

Bearing Cup Installer Easily and accurately install bolt-retained bearing caps in minutes on 1610-1880 yokes. . Reduces the risk of damaging needle bearing during installation. . Install bearing cup without the use of hammer, eliminating potential for...

Brake Anchor Pin Press Removes brake anchor pins and bushings on 16-1/2IN S-Cam trailers and Tractor Q brake systems. No need to remove hub or dust shield. 10 Ton capacity C-Frame. Easily removes seized anchor pins. Design for use with 1/2IN Impact...

Brake Clevis Pin Press Tool is designed to shear off the cotter pin, or the cotter pin can be ground off. .Works on most models of automatic slack adjuster rod pins found on class 6-8 trucks and equipment. 41850

Buy (1) Automatic Brake Slack Adjustment Puller (1) S-Cam Air Brake Spring Tool Service all S-cam air brake slack adjusters.. Works on Rockwell, Haldex, Gunite, and Bendix automatic adjusters.. Get (1) S-Cam Air Brake Spring Tool 50565081

Buy (1) Heavy Duty U-Joint Puller (1) Stinger Heavy Duty Snap Ring Plier Set This heavy-duty tool is used to remove the HD vehicle driveline U-joints using an impact wrench up to 1-inch. Disassemble and reassemble U-joint cups without heat or hammering...

Ford Clutch Coupling Tool Ford Clutch Coupling Tool. Disconnects the hydraulic clutch line from the clutch slave cylinder on the following vehicles with manual transmissions and hydraulic clutches: 1988–newer F-series trucks, Bronco II, Ranger, Explorer,...

HD Bearing Cup Installer Easily and quickly install bearing cups and Dana/Spicer SPL quick disconnect universal joints. . Includes three press bearing adapters designed to fit manufacturer's recommended depths. . Designed to be used with manual and...

HD Truck U-Joint Puller Manufactured from heavy-duty steel materials. Designed for use on bearing cup outer diameter (O.D) 1.5 in - 2.25in.. Eliminates using vice-and-socket or hammering methods which can be dangerous or cause damage. Aid in reducing...

HD Yoke Puller Safe & Fast solution for the removal of commercial yokes, driveshafts, transmissions and rear-end differentials. . Generates up to 25,000 lbs. of pulling force. . Designed to be used with a 1-inch Impact tool.. Made of high-quality...

Heavy Duty U-Joint Puller This heavy-duty tool is used to remove the HD vehicle driveline U-joints using an impact wrench up to 1-inch. Disassemble and reassemble U-joint cups without heat or hammering. Larger diameter threaded shaft can handle U-joints...

Heavy Truck 7/16" Haldex Automatic Slack Adjuster Wrench For brake adjustment on heavy-duty trucks equipped with Haldex slack adjusters. Extra-long handle provides comfort while overcoming the anti-reverse mechanism (22-25 lbs./ft.) 7578

Heavy-Duty Yoke Puller For use on yokes with a bearing diameter between 1-7/8 and 2-3/16. .These yokes are commonly found on Class 6-8 trucks. .Kit comes with strong, grade eight bolts. .All components are heat-treated. 60050