Pullers

T.O Clamp For hard-to-pull areas such as frame rail ends, core supports, box sides, cowls. . Original straight tooth design. 0550

T.O Clamp Mo-Clamp's re-introduced the Tight Opening Clamp because popular demands had to be met so the old design is back. Still a full 3 ton capacity. Still able to reach core support and upper sheet metal areas where no other can. Perfect for small...

Tac-N-Pull Replacement Plate Kit Pull plate kit, includes ten MCL-0801’s, five MCL-0802’s and five MCL-0803’s 0805

Tac-N-Pull with Pull Plates Great for hard to hold pulls. Includes two 3” pull plates, two 1 1/2” pull plates, and two 1” pull plates 0800

The PMXPWP915KIT Fuel Injector Puller Combo The PMXPWP915KIT Ford EcoBoost™ Fuel Injector Puller Combo Kit by ProMAXX Tool is the all-in-one solution for removing stuck injectors across four Ford engine platforms: 1.0L, 1.5L, 3.5L, and 3.7L EcoBoost™. ...

Three Leg Quick Change Puller Eliminates need to remove radiator. No need for bolts. Push-Turn-Click design. Applications:. General Motors 5.3L, 5.7L LS1, 6.0L LS2, 6.2L LS3 and 7.0 L engines.. Ford Coyote 5.0L, 4.6L and 5.4L Triton engines and other 3...

Three-in-One "Griplock" Puller, 2-Ton OTC Three-in-One Griplock Puller manufactured to OTC's rigorous specifications to ensure the quality professionals expect from OTC. . Pressure bearing yoke cap holds jaws in place for ease of set up - in any...

Three-in-One "Griplock" Puller, 5-Ton OTC Three-in-One Griplock Puller Manufactured to OTC's rigorous specifications to ensure the quality professionals expect from OTC. . Pressure bearing yoke cap holds jaws in place for ease of set up - in any...

Tie Down "J" Hook with 3/8" Chain Particularly good for use with SUVs and light trucks for quick anchoring, but works with most any vehicle.. 4 Ton Capacity. Made in the USA. Overall length - 12” 6317

Tie Down “J” Hook with Grab Hook Particularly good for use with SUVs and light trucks for quick anchoring, but works with most any vehicle.. 4 Ton Capacity. Made in the USA. Overall length - 9” 6318

Tommy 475 Wheel Hub Puller Bs Kt :Hub Flnge and Oxde Drve Shft for techs who own bi-direct air hmmr Smart, Centered Pulling Without Damage: Uses a bi-directional air hammer and drive shaft to apply centered pulling force, avoiding damage to the spindle,...

Toyota Front Hub Nut Socket For removal and installation of front hub lock nut on 2007 & Up 2WD Toyota Trucks. 3/4 Drive. Comparable to Factory Tool # 09318-12010-8PI & 09602-60010 1724