Simpson Strong-Tie

The LUS is an easy-to-install, economical hanger designed for common lumber sizes. This widely used hanger features double-shear nailing that distributes the load through two points on each joist...

SET-3G is an epoxy-based anchoring adhesive with high design strength and proven performance. The adhesive is a 1:1 ratio, two-component, anchoring adhesive formulated for anchoring threaded rod and...

Offers various solutions for connecting the stud to the top and bottom plates. 3-9/16" W x 8-3/4" L. Install with 10-10d x 1-1/2" fasteners. 18-gauge galvanized steel.

Offers various solutions for connecting the stud to the top and bottom plates. 20-gauge galvanized steel. May also be available with ZMAX coating.

The standard U hanger provides flexibility of joist to header installation. Versatile fastener selection with tested allowable loads. 16-gauge galvanized steel.

The standard U hanger provides flexibility of joist to header installation. Versatile fastener selection with tested allowable loads. 16-gauge galvanized steel.

All hangers in this series have double shear nailing - an innovation that distributes the load through 2 points on each joist nail for greater strength. This allows for fewer nails, faster...

The innovative ITS sets a new standard for engineered wood top flange hangers. The ITS installs faster and uses fewer nails than any other EWP top flange hanger. The new Strong-Grip seat and Funnel...

The column base is designed to connect posts to concrete foundations for a wide range of lumber, glulam, and engineered wood product sizes. This column base is either cast-in-place or wet set into...

These connectors are always installed in pairs and connect 6X lumber at right angles. Eliminates driving nails into end grain. Nails can be added in triangle holes to increase uplift load capacity...

Simpson Strong Tie piling straps connect wood pilings to floor girders. Hot-dip galvanized for corrosion protection in coastal environments. Piling strap design loads must be determined by the...

1/4" diameter structural wood screw used to install deck ledgers to band joists and meet requirements of building codes. Double-barrier coating (equivalent to hot galvanized) is suitable for outdoor...