OTC Tools & Equipment

Davco Diesel Filter Wrench Davco Diesel Filter Wrench Found on Catepillar, Cummins, Detroit Diesel, International, Mack, Mercedes-Benz, Volvo and other engines. Fits Davco Fuel filters 382 & 384...

Davco Diesel Filter Wrench Found on Catepillar, Cummins, Detroit Diesel, International, Mack, Mercedes-Benz, Volvo and other engines. Fits Davco Diesel filter models, 232-233-234. Durable, stainless...

Caliper Hanger Set These hangers are designed to hold brake calipers out of your way during brake, bearing, suspension, or axle work. In doing so, they make the jobs easier and faster, and reduce...

Ford 6.0L Diesel IPR Controller When a hard start or no start condition exists, the 6764 from OTC allows a technician to close the Injector Pressure Regulator in order to determine if proper injector...

Fuel Filter Wrench, FORD 6.0L & 7.3L The new 6760 Fuel Filter Wrench is designed to remove and install the fuel filters on the Ford 6.0L & 7.3L Power Stroke diesel engines as well as International /...

Universal Inner C.V. Joint Puller No. 7507 – CV joint fork only. Use with OTC slide hammer No. 1155, extension No. 7508, or both. 7507

Outer Tie Rod Remover Outer Tie Rod Remover/Ball Joint Separator This tool is a must when you’re servicing outer tie rods and ball joints. It works on imported and domestic models, front or rear...

Ford Axle Shaft Seal Installers Correctly installs the seal onto the axle shaft and into the wheel knuckle, preventing front hub vacuum leaks that would cause the 4WD to not engage. Works on...

Ford Axle Shaft Seal Installers Correctly installs the seal onto the axle shaft and into the wheel knuckle, preventing front hub vacuum leaks that would cause the 4WD to not engage. Works on...

Truck Clutch Alignment Shaft 1-3/4; O.D., 1; Pilot. Constructed of a lightweight fiberglass-reinforced nylon body that won't hang up in the clutch disc splines. Designed for perfect fit to the spline...

Steering Wheel/Flywheel Puller Pulls steering wheel on most makes of late model cars. Supplied with five pairs of cap screws: 3/8-16 x 3-1/2”; 5/16-18 x 3-1/2”; 5/16-24 x 3-1/2”; M8-1.25 x 90mm; and...

Universal Belt Tension Gauge Universal Belt Tension Gauge. Belt tension gauges are used to check drive belt tension on drive belts to ensure maximum belt and bearing life.. Scale reads 30–180 inch...