OTC Tools & Equipment

Torque Multiplier, 2000 lb-ft Drive Input; 3/4, 730 lb-ft Max. Drive Output; 1, 2200 lb-ft Max. Head Width; 3.6, 3.3:1 Ratio. Reaction Bar; 15-5/8. Includes reaction foot.. Note: frictional gear...

Ford Spark Plug Remover Kit, Triton 3V Unique design helps prevent breakage by locking the plug porcelain core to the plug hex allowing it to turn as one complete unit.. Will also pull plug porcelain...

Battery Terminal Service Kit Test automotive batteries and create health reports. Works on 6V and 12V automotive batteries - regular flooded, enhanced flooded, AGM, EV and start-stop.. 12V/24V...

WHEEL BEARING REMOVAL AND INSTALLATION KIT Wheel Bearing Removal/Installation Kit Features:. This tool assembly will remove and install 3/4 inch, 1 inch, and 25 millimeter I.D. sealed wheel bearings...

Receiving Tube 2-3/4", For Ball Joint Service 2-1/2 OD, 2-1/4 ID, 2-3/4 long 222305

Detroit Diesel Engine Adp Product Features.Designed for mounting Detroit Diesel DD13 and DD15 Engines.Use with OTC 1750 1750A Revolver Diesel Engine Stand 1750-47389

Mack/Volvo Engine Adp Product Features.Designed for mounting Mack/Volvo MP7/D11 Engines.Use with OTC 1750 1750A Revolver Diesel Engine Stand 1750-47366

Ball Hone Set (10 piece) Ball Hones can be used for refinishing and resizing bores such as found in brake calipers, engine lifters, and u-joint yoke's. Also useful for any bearing or bushing...

Injector Sleeve Service Set Set includes tools to remove fuel injector sleeves, clean the injector bore and fuel galley, and install injector sleeve cups. With the head removed, the slide hammer...

Angled Wire Stripping Tool This tool puts the stripping dies on the angled tip - above the pivot point. . The patented angle design gives you the right angle to neatly strip or wires in tough to...

Crankshaft Seal And Wear Sleeve Installer This tool installs the front and rear crankshaft wear sleeves and seals. It eliminates lip flare on the wear sleeve and installs the seal properly. For use...

Cam Gear Alignment Fixture This tool pulls the cam drive gear hub and thrust plate forward for camshaft and/or thrust plate seal removal and installation. For use on Detroit Diesel Series 60 engines...