Heating and Cooling

3" termination cap. Type L insulated pipe for pellet stove applications. Design to prevent rain and snow from entering the pipe.

(DSAC)-with coupler. For use in new installations, this part can be installed by twist-locking the coupler on the DSAC into the first section of Model SSII type HT chimney pipe. Used to connect either model DS smoke pipe or single wall stove pipe to SSII...

(DSA)-without coupler. For use in retrofit installations, this part can be installed from below with a finish support package and secured with screws. Used to connect either model DS smoke pipe or single wall stove pipe to SSII type HT insulated chimney...

Used to start chimneys indoors or outdoors using a wall support assembly or masonry pier. Insulated tee cap included, removable for inspection and cleanout. Maximum height of chimney which can be supported by an insulated tee is 50'.

Includes the basic components for a standard installation (2/12 - 6/12). Contains 1 round top, 1 storm collar, and 1 roof flashing. For use with Model SSII Type HT chimneys.

For a wall supported chimney system with a horizontal connector passing through an exterior wall, connecting to a Tee and running vertically up the exterior wall to termination above the roof line. The Thru-the-Wall Support Kit provides all necessary...

Stainless steel outer casing and inner liner. Double-wall pipe with solid pack insulation. Tested to withstand 2100 F (degree Fahrenheit). UL (Underwriters' Laboratories) listed. This test helps to prevent product damage or structural hazard during brief...

Designed to keep errant sparks from leaving the chimney and to prevent wildlife from entering the chimney system. Fits over exterior of same size round chimney top. Easy and quick installation and removal for inspection and cleaning. diamond mesh.

Exit cap for pellet stove pipe, 5-3/4" high for 3" pipe. Galvanized.

Elbow kit includes two elbows, 2 locking bands and 1 interior re-support. This kit allows the chimney to be offset in a way to avoid obstructions that may occur prior to exiting the roof. UL standard 103 prohibits angles greater than 30 degrees. The...

Elbow kit includes two elbows, 2 locking bands and 1 interior re-support. This kit allows the chimney to be offset in a way to avoid obstructions that may occur prior to exiting the roof. UL standard 103 prohibits angles greater than 30 degrees. The...

For increasing stability of Sure-Temp stainless steel insulated pipe. Inward flanges around the band fit into grooves at pipe joints. Reinforces joints of chimney suspended below support assemblies and prevents accidental uncoupling. Reinforces joints of...