Heating and Cooling

Designed with a dome to exclude rain and leaves and a lower skirt to deflect wind for proper chimney draft. The three legs slide down over the outside of the chimney pipe. A cinch band is then positioned over the legs and tightened to hold the top firmly...

Stainless steel outer casing and inner liner. Double-wall pipe with solid pack insulation. Tested to withstand 2100 F (degree Fahrenheit). UL (Underwriters' Laboratories) listed. This test helps to prevent product damage or structural hazard during brief...

Designed with a dome to exclude rain and leaves and a lower skirt to deflect wind for proper chimney draft. The three legs slide down over the outside of the chimney pipe. A cinch band is then positioned over the legs and tightened to hold the top firmly...

Converts a SC series cap into a slip-in model. This heavy-duty stainless steel leg kit is used when the flue tile does not extend above the chimney crown. Includes set of four legs. Designed for use with HY-C Shelter SC Series chimney covers.

Stainless steel outer casing and inner liner. Double-wall pipe with solid pack insulation. Tested to withstand 2100 F (degree Fahrenheit). UL (Underwriters' Laboratories) listed. This test helps to prevent product damage or structural hazard during brief...

Type L insulated 3" adapter for pellet stove applications. SSII pellet stove pipe adapter, used to transition VP Pellet Pipe to Ultra-Temp chimney.

Used along wall to provide for 2 In. clearance and assure stability. Also useful for suspending offsets. Required at 8 Ft. or closer intervals to stabilize the chimney, wherever it is supported along a vertical wall. Actual band diameter is 8 In. to...

Stainless steel outer casing and inner liner. Double-wall pipe with solid pack insulation. Tested to withstand 2100 F (degree Fahrenheit). UL (Underwriters' Laboratories) listed. This test helps to prevent product damage or structural hazard during brief...

3" termination cap. Type L insulated pipe for pellet stove applications. Design to prevent rain and snow from entering the pipe.

Elbow kit includes two elbows, 2 locking bands and 1 interior re-support. This kit allows the chimney to be offset in a way to avoid obstructions that may occur prior to exiting the roof. UL standard 103 prohibits angles greater than 30 degrees. The...

For freestanding fireplaces and open cathedral ceiling installations. Fits all roof pitches and requires only simple framing. Mounts easily onto top of roof through opening that allows 2" clearance. Maximum length of chimney which can be suspended below...

Used along wall to provide for 2 In. clearance and assure stability. Also useful for suspending offsets. Required at 8 Ft. or closer intervals to stabilize the chimney, wherever it is supported along a vertical wall. Actual band diameter is 10 In. to...