Heating and Cooling

Easy to assemble and can be combined to obtain the required installation height. Couplers overlap 1-1/2" when joined. Assembled length is 1-1/2" less than listed lengths. Size refers to the inside diameter of the pipe or fitting. The outside diameter of...

Provides a decorative/finished appearance. May be used as firestop for openings in floors, ceilings and walls. C 2-3/8". Size refers to the inside diameter of the pipe or fitting. The outside diameter of RV is approximately 1/2" larger. Type B gas vent.

External screen prevents entry of most bird species. Aluminum top and galvanized flashing. Slips inside of pipe and locks into place with spring clips. Must not be used for woodburning applications. Size refers to the inside diameter of the pipe or...

Easy to assemble and can be combined to obtain the required installation height. Couplers overlap 1-1/2" when joined. Assembled length is 1-1/2" less than listed lengths. Size refers to the inside diameter of the pipe or fitting. The outside diameter of...

Used to provide a weatherproof seal to pipe above roof line. Used above the flashing. Seal inner edge with hi-temp silicone sealant. Type B gas vent.

For use with the Insulated Tee as an interior or exterior support where the chimney has a lateral connection. Also useful where the pipe connection passes through a combustible interior or exterior wall. Braces may only be fastened to the wall below the...

Used along wall to provide for 2 In. clearance and assure stability. Also useful for suspending offsets. Required at 8 Ft. or closer intervals to stabilize the chimney, wherever it is supported along a vertical wall. Actual band diameter is 10 In. to...

3", 45 deg (degree) elbow. Type L insulated pipe for pellet stove applications. Used to offset pipe around construction obstacles. Factory sealed at couplers to prevent leakage. A = 3-7/16". Stainless steel liner and galvanized jacket.

3" termination cap. Type L insulated pipe for pellet stove applications. Design to prevent rain and snow from entering the pipe.

The Over The Top universal dryer vent kit feature two 4-foot sections of pipe attached to two close elbows and two clamps for wall and dryer connections. This 8-foot kit installs in 4.5" when the wall pipe is trimmed flush and the wall plate is used...

All aluminum. Will not warp or crack. Includes backdraft damper.

Kit includes: 4" x 8' dryer duct, plastic duct to dryer connector, and optional plastic extension piece. Connects clothes dryer exhaust port to exhaust duct. Friction fit for an easy connection that does not require clamps or duct tape. Connector is made...