Punch and Chisels

1/4" x 6" Roll Pin Punch Used primarily to remove roll pin punches. .The center of the tip of the punch has a rounded center section that fits inside the hole created by the roll pin. .This helps prevent damaging the roll pin and easy removal of the pin...

1/4" x 6" x 1/2" Starter Punch Softened and Tapered Striking end reduces potential to chip. Ground surface for ease of identification. Precision Harded working ends. Used For Marking Center Lines and Pilot Drill Locations. Meets or exceeds ASME B107.47...

1/4" x 7" x 3/8" Pin Punch Softened and Tapered Striking end reduces potential to chip. Ground surface for ease of identification. Precision Harded working ends. Used For Marking Center Lines and Pilot Drill Locations. Meets or exceeds ASME B107.47 82276

1/4? Brass Pin Punch Brass punches are used instead of steel punches in non- marring applications and to constrain sparking. The consumable brass is designed not to mar steel. Many sizes are available for proper application. Made in the USA. 25090

1/4? Pro Solid Punch Solid punches are used for loosening seized or tight pins or keys, or knocking out rivets. Many sizes are available to match different sized keys and pins. Used in conjunction with pin punches. Punches are covered with a black oxide...

1/8 Long Pin Punch, 150 Line High Grade S-2 steel. Full shank heat treating and parabolic head to reduce mushrooming and chipping of the struck end 15081

1/8" x 5" x 5/16" Pin Punch Softened and Tapered Striking end reduces potential to chip. Ground surface for ease of identification. Precision Harded working ends. Used For Final Removal To Drive Out Pins and Rivets. Meets or exceeds ASME B107.47 82273

1/8" x 6" Roll Pin Punch Used primarily to remove roll pin punches. .The center of the tip of the punch has a rounded center section that fits inside the hole created by the roll pin. .This helps prevent damaging the roll pin and easy removal of the pin...

1/8" x 8" x 3/8" Long Taper Punch Softened and Tapered Striking end reduces potential to chip. Ground surface for ease of identification. Precision Harded working ends. Used To Install and Remove Pins and Shafts and To Align Holes. Meets or exceeds ASME...

1/8? Pro Solid Punch Solid punches are used for loosening seized or tight pins or keys, or knocking out rivets. Many sizes are available to match different sized keys and pins. Used in conjunction with pin punches. Punches are covered with a black oxide...

10 Pc. .401 Shank General Service Chisel Set This set contains the most popular .401 shank chisels to handle a wide variety of job types. Comes with a Molded Storage Tray. Set includes:. 3/4 x 7” Flat Chisel (CH102). 7” Claw Ripper & Panel Cutter (CH110)...

10 PIECE COLD CHISEL SET 61510 Heat treated for maximum strength. New anti-slip pouch. Black Oxide finish. Made in the USA 61510