Punch and Chisels

1/4" x 7" x 3/8" Pin Punch Softened and Tapered Striking end reduces potential to chip. Ground surface for ease of identification. Precision Harded working ends. Used For Marking Center Lines and Pilot Drill Locations. Meets or exceeds ASME B107.47 82276

1/4? Brass Pin Punch Brass punches are used instead of steel punches in non- marring applications and to constrain sparking. The consumable brass is designed not to mar steel. Many sizes are available for proper application. Made in the USA. 25090

1/4? Pro Solid Punch Solid punches are used for loosening seized or tight pins or keys, or knocking out rivets. Many sizes are available to match different sized keys and pins. Used in conjunction with pin punches. Punches are covered with a black oxide...

1/8 Long Pin Punch, 150 Line High Grade S-2 steel. Full shank heat treating and parabolic head to reduce mushrooming and chipping of the struck end 15081

1/8" x 5" x 5/16" Pin Punch Softened and Tapered Striking end reduces potential to chip. Ground surface for ease of identification. Precision Harded working ends. Used For Final Removal To Drive Out Pins and Rivets. Meets or exceeds ASME B107.47 82273

1/8" x 8" x 3/8" Long Taper Punch Softened and Tapered Striking end reduces potential to chip. Ground surface for ease of identification. Precision Harded working ends. Used To Install and Remove Pins and Shafts and To Align Holes. Meets or exceeds ASME...

1/8? Pro Solid Punch Solid punches are used for loosening seized or tight pins or keys, or knocking out rivets. Many sizes are available to match different sized keys and pins. Used in conjunction with pin punches. Punches are covered with a black oxide...

10 Pc. .401 Shank General Service Chisel Set This set contains the most popular .401 shank chisels to handle a wide variety of job types. Comes with a Molded Storage Tray. Set includes:. 3/4 x 7” Flat Chisel (CH102). 7” Claw Ripper & Panel Cutter (CH110)...

10 PIECE COLD CHISEL SET 61510 Heat treated for maximum strength. New anti-slip pouch. Black Oxide finish. Made in the USA 61510

100-3/4 Brass Drift Punch KNRLD Features and Benefits: For non-marring and non-sparking applications. Designed for use on harder surface materials that will not be damaged by the softer brass punches. For aligning unhardened steel or aluminum. 25075

105-1/2" BEARING RACE PUNCH Used to remove bearing races in automotive and industrial settings. Larger tips are designed for larger bearing sizes. Specially heat -treated still makes these tools ideal for stubborn bearing races 24549

105-9/16" Bearing Race Punch Used to remove bearing races in automotive and industrial settings. Larger tips are designed for larger bearing sizes. Specially heat -treated still makes these tools ideal for stubborn bearing races 24551