Punch and Chisels

1-1/2" x 7" Flat Chisel, .498 Drive .498 Drive. Heavy Duty Blister Pack CH803

1-1/4” Smoothing Hammer Slightly oval face for smoothing sheet metal, rivet setting, knock out, etc. . Made from the best shock-resisting alloy steel available. Designed to fit all popular air hammers with a standard .401 shank 5714

1-1/4" x 7" Chisel & Scraper .498 Drive. Heavy Duty Blister Pack CH812

1-1/8" (29mm) Pro Sep. Fork Designed to separate ball joints and tie rods quickly and easily with minimal shock to the assembly 31934

1/2 in. Drive Construction Ratchet 72 Tooth reversible ratchet . 5 degrees of sweep for working in confined areas . Black Oxide finish . Overall length: 12 in. . Item UPC: 802090110788 11078

1/2" Reg Cape Chisel Also known as a slot chisel . Used to flat grooves for keyways or slots . Narrows to a flat cutting end for precision . Available in varying cuts and lengths, for varying sizes of grooves . Black oxide finish for additional rust...

1/2" Reg Ec Center Punch Used for piercing, or marking for starting drills in metal and other materials . Available in a shot-blasted finish . Made in the USA 74003

1/2? PRO COLD CHISEL Cold Chisels act to shape and cold metal only. These chisels are specially angled for strength and available in a black oxide finish to deter rust. Many lengths and sizes are offered to fit any application. All cold chisels are made...

1/4 X 14" Pro Line-Up Punch Line-up punches are used to align the holes through which rivets, pins, or bolts will be inserted, but not for driving the hardware. Sizes vary for the optimal alignment. A black oxide finish is available for rust protection...

1/4” Reg Center Punch Used for piercing, or marking for starting drills, in metal and other materials. Point sizes vary for larger or smaller holes. Available in black oxide finish for additional rust protection 24000

1/4" x 11" x 5/8" Long Taper Punch Softened and Tapered Striking end reduces potential to chip. Ground surface for ease of identification. Precision Harded working ends. Used To Install and Remove Pins and Shafts and To Align Holes. Meets or exceeds ASME...

1/4" x 6" x 1/2" Starter Punch Softened and Tapered Striking end reduces potential to chip. Ground surface for ease of identification. Precision Harded working ends. Used For Marking Center Lines and Pilot Drill Locations. Meets or exceeds ASME B107.47...