Punch and Chisels

1973 Cold Chisel 8" Features and Benefits: Designed to bolts, nuts, tees, angles and frame members Blade width is 5/8 Designed for use with a .401 Parker shank Finished in black oxide Made in the U.S.A. 31973

1975 Rivet/Bolt Cutter Features and Benefits: Black oxide finish Use with .401 Parker shank Built with the beef and edge to rivets and bolts in bumpers, grilles, frames and brackets Blade width is 5/8 6-1/2 in length 31975

1976 Scraper Features and Benefits: Black oxide finish Use with .401 Parker shank Removes gaskets, rust, undercoating, paint, floor tile, plaster and roof coatings with ease The blade is 1-1/8 wide, 8 long, and offset for hand clearance 31976

1977 6IN Taper Punch Sharp PT Features and Benefits: Punches holes in sheet metal for entrance of screws or wires Designed to use with .401 Parker shank Finished in black oxide Made in the U.S.A. 31977

1978 18" Taper Punch Sharp PT Features and Benefits: Punches holes in sheet metal for entrance of screws or wires Designed to use with .401 Parker shank Finished in black oxide Made in the U.S.A. 31978

1979 Taper Punch 3/8 DIA PT Features and Benefits: Use for peening and crimping bodies, driving rivets and hinge pins 3/8 tip 31979

1980 Taper Punch 1/2 DIA PT Features and Benefits: Use for peening and crimping bodies, driving rivets and hinge pins 1/2 tip 31980

1982 Pnuematic 4" Hammer Features and Benefits: Excellent for hammering operations such as U-joints, ball joint and body forming work 31982

1986 Cold Chisel 18" Features and Benefits: Black oxide finish Use with .401 Parker shank Designed to bolts, nuts, tees, angles and frame members Blade width is 5/8 31986

1987 6" Pnuematic Hammer Features and Benefits: Used in hard-to-reach areas Excellent for hammering operations such as U-joints, ball joint and body forming work 31987

1997 Taper Punch Features and Benefits: The 1/8 diameter point will drive out pins and rivets 6-1/2 in length Weight: .34 lbs. 31997

2011 Taper Punch 3/8"-18 2011 TAPER PUNCH 3/8-18 32011