Square End Mill, 1 in Milling Dia., Cobalt, Uncoated, Non-Coolant Through, Weldon Flat, Length of 3 in, Overall Length 5 1/2 in, Shank Dia. 1 in, Neck Dia. Not Applicable

Tapered End Mill, Tapered, Cobalt, 3 Degrees Taper Angle per Side, 1/4 in Tip Dia., Uncoated, Inch, 3/4 in

O-Ring, Metal Detectable Metal Detectable, Not X-Ray Detectable X-Ray Detectable, System of Measurement Metric, Cross Section Shape Round, O-Ring Material , Durometer (Hardness) Rating Medium Hard, Nominal Inside Dia. 26 mm, Nominal Width 3 mm, Actual...

Corner Radius End Mill, 0.5 in Milling Dia., Carbide, TiAlN, Straight, Inch, 0.06 in, 1 in, 3 in

Male-End Leveling Mount, Leveling Mount Type Swiveling Stud, Base Dia. 5 in, Height 12.25 in, Load Capacity 10,000 lb, Thread Size 1 In.-8, Construction Steel, Hex 1-3/8 in, Includes Jam Nut, Connection Type Threaded Stud, Bolt Length 10 in, Base...

Ball End Mill, 0.234375 in Milling Dia., Carbide, TiAlN, Non-Coolant Through

Ball End Mill, 7 mm Milling Dia., Carbide, TiAlN, Non-Coolant Through

USB Cable, USB Specification Not Applicable, Color Black

LDPE Sheet, LDPE, Grade Standard, Plastic Length 4 ft, Plastic Width 24 in, Plastic Thickness 0.25 in, Off-White, Plastic Clarity Opaque, Tensile Strength 1,700 psi, Impact Strength No Break, Friction Coefficient 0.12, Water Absorption 0.01 Percent,...

Jobber Length Drill Bit, Drill Bit Size 8.10 mm, Drill Bit Point Angle 120 Degrees , High Speed Steel, TiN, Decimal Equivalent 0.3189, Metric, Drill Bit Point Type S Thinning Point, Non-Coolant Through

Ball End Mill, 8 mm Milling Dia., Carbide, EXO, Non-Coolant Through

Ball End Mill, 2 mm Milling Dia., Carbide, WXS, Non-Coolant Through