Pumps

Permit water to flow in one direction within a line with the ProLine Series PVC Check Valve. It acts as a backflow prevention device to prevent water from backing up into the fresh water supply. A steel-spring poppet with a rubber o-ring is the internal...

Designed for proper driving of well points. Has inside recess to prevent damage to pipe threads. Octagon shaped for positive wrenching. Threads are standard pipe size, small vent hole in top of casting relieves pressure during driving operation.

Silicon bronze valve body and poppet assembly. Furnished with buna-n O-ring, stainless steel spring, stainless steel washer, and stainless steel locknut. Check valves have a working pressure of 400 P.S.I. FPT. x FPT. Code approved in California.

For plunger assembly. Used for pitcher pump.

Includes ejector, gasket, and bolts. Will lift water from depths of up to 90'. Must be 4" minimum well casing for deep-well application. Dual voltage (115V/230V). Pressure switch factory preset at charted discharge pressure.

Includes ejector, gasket, and bolts. Will lift water from depths of up to 90'. Must be 4" minimum well casing for deep-well application. Dual voltage (115V/230V). Pressure switch factory preset at charted discharge pressure.

The Superior Pump 25 Ft. lay-flat discharge hose kit is designed to work with most sump and utility pumps with a pump discharge size of 1-1/4 In. or 1-1/2 In. The 25 Ft. long x 1-1/2 In. diameter lay-flat hose is made from reinforced PVC and easily rolls...

Superior Pump builds pumps that are truly built to last and are 100% factory tested. Superior Pump uses quality components including solid copper motor windings, heavy-duty stainless steel jacketed shaft seals, double o-ring seals on motor plate, and...

Superior Pump builds pumps that are truly built to last and are 100% factory tested. Superior Pump uses quality components including solid copper motor windings, heavy-duty stainless steel jacketed shaft seals, double o-ring seals on motor plate, and...

Factory pre-charge: 38 psi (pounds per square inch). Maximum working pressure 100 psi. Maximum operating temperature 200 F (degree Fahrenheit). Engineered to provide years of trouble-free service using cold rolled steel for a higher strength to weight...

Diaphragm-type pre-pressurized expansion tank specifically designed for potable hot water systems. These tanks control water pressure build-up and eliminate relief valve spillage caused by thermal expansion when water is heated. 3/4" Male pipe thread...

Zoeller Pro Cast Iron Sump Pump, non-clogging vortex impeller. 1-1/2 In. NPT discharge - passes 3/8 In. solids. All stainless steel hardware. Premium vertical switch easily fits into as small as a 10 In. sump basin. Rugged cast iron motor housing for...