Other

Galvanized straight tee joint used as a 90 deg (degree) branch for venting, including heating and air conditioning.

The Lambro 3-1/4 In. x 10 In. galvanized steel short way 90 degree rectangular elbow used for HVAC systems or range hood venting. The elbow is made of zinc-coated 30 gauge galvanized steel and provides advanced corrosion protection with pre-installed...

The Lambro 3-1/4 In. x 10 In. to 6 In. round galvanized steel straight register boot used for HVAC systems, floor registers or range hood venting. Installations consist of transitioning from round pipe or flexible insulated duct to rectangular stack duct...

For dryers, bathroom vents, and range hoods. J-block nail flange included for use in new construction (can be discarded or recycled if application is not for new construction). Vent cap wide-mount faceplate is 6-3/4" W. x 7-3/8" H. and ideal when needing...

Stainless steel outer casing and inner liner. Double-wall pipe with solid pack insulation. Tested to withstand 2100 F (degree Fahrenheit). UL (Underwriters' Laboratories) listed. This test helps to prevent product damage or structural hazard during brief...

Round vent is UV (ultraviolet) stabilized polymer resin with a molded in mesh screen. Extra long collar for better duct connection. Secure friction fit in the soffit.

Used to reduce diameter of galvanized round perimeter pipe. For single wall pipe. Small end is crimped. Overall length is 6 In.

For gas heating, ventilation, and air conditioning only. Not for use with solid fuel appliances. Outside surface smooth. Snap-lock.

For gas heating, ventilation, and air conditioning only. Not for use with solid fuel appliances. Outside surface smooth. Snap-lock.

30-gauge. 6" diameter. 90 deg. angle. Made from 1 piece of metal for extra strength.

Replacement tank top thermocouple assembly with tip-over switch for HR. HEATER models MH15T, MH15TS, MH30T, MH30TS, MH45T and Sunrite Models SRC15T, SRC30T. Tip-over switch detects unsafe angle and shuts off gas flow. Replaces part 17349.

For dryers, bathroom vents, and range hoods. J-block nail flange included for use in new construction (can be discarded or recycled if application is not for new construction). Vent cap wide-mount faceplate is 6-3/4" W. x 7-3/8" H. and ideal when needing...