Pullers

Cone-type Puller Cone-type Puller Reversible jaws permit handling of both internal and external pulling jobs. The 2-way/3-way head permits assembly of puller to suit the job at hand. Turning the cone on the puller head securely locks its jaws on the part...

Crank Sensor Alignment Tool Aligns the crankshaft position sensor properly during installation. Similar to 303-1521.. Applications include:. 2012-Later 2.0L Duratec, EcoBoost and GTDI. 2015-Later 2.3L EcoBoost. Applications include: 2012-Later 2.0L...

Crankshaft & Camshaft Seal Tool Kit Easily remove and install crankshaft and camshaft seals without damage. Compact puller with unique extracting hooks engage seal for quick removal. Interchangeable sleeves and mandrels allow easy installation of new...

Crankshaft Front Seal And Wear Ring Remover Removes the front seal and wear ring from crankshaft. Similar to 303-1260.. Applications include:. 2008-2010 Ford F-250, F350, F450, F-550. 6.4L Ford Powerstroke engines. VT365-MaxxForce7. Navistar...

Crankshaft Rear Oil Seal Installer The OTC 6895 Crankshaft Rear Oil Seal Installer is used to install crankshaft rear main oil seal. Similar to OE part number 303-328.. Applications include Ford, Lincoln and Mercury vehicles using the following engines:...

Crankshaft Rear Seal And Wear Ring Installer The OTC 6885 installs the rear seal and wear ring on crankshaft. It's designed to eliminate lip flare on the wear sleeve and install the seal properly. Similar to OE part number 303-770/. Applications include...

Crankshaft Seal And Wear Sleeve Installer This tool installs the front and rear crankshaft wear sleeves and seals. It eliminates lip flare on the wear sleeve and installs the seal properly. For use on Detroit Diesel Series 60 and two cycle 92 engines...

Crankshaft Seal Installer Installs front crankshaft seal on 2012-2013 Chevrolet Sonic, 2012 Aveo, 2011-2012 Cruze, 2011-2012 Volt. Similar to KM-960 6742

Cummins 22mm & 19mm Fuel Line Sockets The 22mm 1/2-inch-drive socket is designed for the Cummins ISX engines. The 19mm 1/2-inch-drive socket is designed for the Cummins ISB engines. With the application of high pressure common rail fuel injection...

Cummins Diesel Fuel Injector Remover Kit Cummins Diesel Fuel Injector Remover Kit Kit contains a fuel injector connector tube remover and fuel injector puller. The fuel injector connector tube must be removed before removal of the injector, or both will...

Cummins Drive-Pulley Tool Set This two-piece set is designed to remove and install the drive pulley on Cummins NH and NTC 855 cubic inch engines . 7120

Cummins Engine Barring Tool Designed to fit the flex plate teeth. Insert the tool into the flywheel housing until it engages the ring gear. Use with a 1/2 square drive tool (ratchet or breaker bar) to operate. Applications: Dodge Pickups with the 3.9L, 5...