Brake Tire & Suspension

Disc Brake Piston Tool Designed to rotate the parking brake activated piston back into the caliper cylinder when replacing worn pads on vehicles equipped with four wheel disc brakes. 5060

Disk Brake Pad Spreader For Installing Pads on Most Domestic and Import Cars and Light Trucks. Makes changing pads an easy job. Tool compresses disc brake piston for easy pad installation. 24400

DLX MEGA AIRBLAST BEAD STR Used on Auto, ATV, and Truck Tires. Designed for use on tires up to 24½ Diameter. CE Certified 5 Gallon Aluminum Tank 31445

Dodge 12 Pin Axle Hub Nut Socket Remove and install rear axle retaining nuts on Dodge Ram H.D. trucks. Fits Rear Hubs on Ram 2019 and up 3500 dual rear wheel trucks, 4500, 5500 (D2, DD, DP) chassis cab trucks. 1/2IN Female drive use with ratchets,...

Dodge Hub Nut Socket Fits rear axle lock nuts of Dodge/ Ramtrucks with six holes. Use this tool when removing and installing rear wheel hubs without the struggles and potential of damage other methods cause. Dodge / RamTrucks 1500 -5500 model years 2006...

Dodge Ram/Jeep Ball Joint Adapter Set Use with the No. 7249 ball joint set to remove or install aftermarket and original equipment upper and lower ball joints, and the offset ball joints used to change caster/camber. Applications: 1984-newer “downsized”...

Dodge Truck Locknut Socket No. 6006 – Services 1994–newer Dodge 1/2-ton 4x4 pickups with Dana 44 front axle and Dana 60 axle with vacuum disconnect front axle. 6006

Dodge Wheel and Hub Removal Adapter Eliminates possible broken rotors when using a sledge hammer . No heavy slide hammers to use. When you use a torch on a stuck hub, the wheel bearing and seal could get damaged 90300

Double Flaring Tool Kit Designed for double or single flare in copper, aluminum, soft steel brake . Includes five adapters 3/16” through 1/2” (4.8mm through 12.7mm). . Chrome swivel, made of alloy steel reduces friction. Forged yoke made of heat-treated...

Double Flaring Tool Kit Chrome swivel, made of alloy steel reduces friction . Forged yoke made of heat-treated steel . Designed for double or single flare in copper, aluminum, soft steel brake line, and brass tubing (to 45 degrees) . Molded storage case...

Double Flaring Tool Set Makes Both Single and Double SAE Flares. This tool set includes everything to flare thin wall steel, aluminum or .040 wall soft copper tubing. The set includes 5 thread dies and adapters for forming double flares on the following...

Double Flaring Tool Set with Cutter Double Flaring Tool Set with Cutter. Designed for steel brake lines where double flaring is required.. Also performs 45° single flares on 3/16, 1/4, 3/8, 7/16, 1/2, and 5/8 copper, aluminum, brass, and magnesium tubing...