SIM Supply, Inc.

Tank to bowl gasket for Eljer brand toilets.

Tank to bowl gasket for American Standard brand toilets. Sponge rubber.

Do it no-seep No. 1 toilet bowl gasket with brass bolts. Wax and flange design. Polyethylene sleeve for strong seal. 1/4" x 2-1/4" brass bolt kit. Fits 3" and 4" waste lines. For floor closet bowls...

Tank to bowl gasket for Gerber toilets.

With double thick sponge gasket for a positive seal on even the most difficult 2-bolt tank to bowl combinations. Packed with instructions on card.

For problem areas that need extra wax or where floor flange is too low (1-1/4" to 1" below finished floor surface). Ready-to-use. Fits 3" or 4" waste lines. Forms a gas-tight, odor-tight, water-tight...

Extra thick wax gasket for problem areas that require more wax. Contains 40% more wax than ordinary gaskets. Provides a more positive seal and requires less installation time than using 2 wax rings...

Fits between toilet tank and bowl for a tight seal. Sponge rubber. Size: 3-1/4" O.D., 2-1/8" I.D., 9/16" tapered wall, 3/4" thick.

Standard size. Fits 3" and 4" lines for floor toilet bowls. Polyethylene flange stops leaks and seepage under bowl. Ideal for DIY. Polyethylene wrapped; 1 per carton.

For floor toilet bowls. Polyethylene wrapped individually boxed for easy installation. Full size.

Urethane reinforced extra thick. Up to 20 times stronger than ordinary wax gaskets. Fits 3" and 4" lines, most wall and all floor toilet bowls. Resilient...springs with bowl movement. Permanent.....