Heating and Cooling

Elbow kit includes two elbows, 2 locking bands and 1 interior re-support. This kit allows the chimney to be offset in a way to avoid obstructions that may occur prior to exiting the roof. UL standard 103 prohibits angles greater than 30 degrees. The...

Elbow kit includes two elbows, 2 locking bands and 1 interior re-support. This kit allows the chimney to be offset in a way to avoid obstructions that may occur prior to exiting the roof. UL standard 103 prohibits angles greater than 30 degrees. The...

DSP6E4-1 45 deg. elbow. Nonpositional connection system allows 360 deg. rotation. Used to offset double wall stove pipe towards insulated chimney. Designed with double wall construction and a durable stainless steel inner liner. Intended to be used in...

Elbow is fixed at 90 deg (degree), but can be rotated 360 deg at the connection. Designed with double wall construction and a durable stainless steel inner liner. Intended to be used in place of standard single wall stove pipe. Used to offset Double Wall...

Used wherever a ceiling support, finish support, or firestop is installed below an open attic. Required to guard against the hazard of blown-in or blanket insulation filling any framed opening or contacting the chimney and possible storage of...

With proper framing, both ceiling supports assure at least 2" minimum clearance to combustibles at the support level and can carry up to 50' of vertical chimney height. Square trim plate. Matte black finish.

Round collar fits over lower end of suspended insulated chimney pipe to provide finished appearance. Used to attach T-DSA Dripless Smoke Pipe Adapter part to lower end of chimney or to insulated tee. Matte black finish.

Designed to fit on the round chimney pipe just above the roof flashing.The upper edge should be waterproofed with plastic sealer to prevent any water from leaking between the storm collar and chimney pipe. Part is tightened with screws or tabs after...

For increasing stability of Sure-Temp stainless steel insulated pipe. Inward flanges around the band fit into grooves at pipe joints. Reinforces joints of chimney suspended below support assemblies and prevents accidental uncoupling. Reinforces joints of...

For installation of a chimney in a cathedral or pitched ceiling such as standard A-frame construction. The Pitched Ceiling Support Kit provides all necessary parts for a complete installation with the exception of the required insulated pipe lengths and...

Designed to keep errant sparks from leaving the chimney and to prevent wildlife from entering the chimney system. Fits over exterior of same size round chimney top. Easy and quick installation and removal for inspection and cleaning. diamond mesh.

Designed with double wall construction and a durable stainless steel inner liner. Intended to be used in place of standard single wall stove pipe. Interlocking joints, secured with screws provided, allow for quick and easy system assembly. Air space...